Free Access Cisco.300-510.v2023-06-10.q145 Practice Test (Page 19)

Question 86

What is determined by running the same hash algorithm on all PIMv2 routers?

A.Auto RP election

B.Which RP to use from a set of candidate RPs in the RP set

C.The SPT from the RP to the multicast source

D.The SPT from the last hop router to the multicast source

E.Which BSR to use for a particular multicast group

Question 87

Refer to the exhibit.

Refer to the exhibit. MPLS traffic from 192.168.4.0/24 to 192.168.5.0/24 is failing to pass over the link from R4 to R2. The engineer verified that:
Cisco Express Forwarding Is enabled on all routers.
All routers reach all networks via OSPF.
MPLS traffic from 192.168.1.0/24 to 192.168.3.0/24 is passing normally over the link from R1 to R2.
Which action resolves the issue?

A.On router R2, configure the mpls ip command on the SIO/O/4 interface.

B.On router R4, remove the mpls ip command on the s/O/O/2 interface.

C.On router R2, configure the mpls label protocol Idp command on the interface.

D.On router R4, configure the mpls label protocol Idp command on all serial interfaces.

Question 88

Drag and drop the attributes for the BGP route selection on the left into the correct order on the right. Not all options are used.

Question 89

What is the characteristic of enabling segment routing for IGPs?

A.Segment routing must first be enabled globally and then under the routing process.

B.Segment routing must first be enabled under the routing process and then globally.

C.Segment routing must be enabled only under the routing process.

D.Segment routing must be enabled only globally.

Question 90

Refer to the exhibit. There is a connectivity issue between Customer-1 and Customer-2 File servers between the customers cannot send critical data R3 routes are missing from the routing table on the Customer-1 router. All interfaces on Customer-1 are up.
Which configuration must be applied to router R2 to correct the problem?