Free Access Cisco.350-401.v2025-07-21.q676 Practice Test (Page 136)

Question 671

What does the Cisco WLC Layer 3 roaming feature allow clients to do?

A.maintain their IP address when roaming to an AP or controller with a different client VLAN assignment

B.maintain their connection between APs even when the AP management VLANs are different

C.maintain their connection even if the client IP address changes when roaming

D.roam seamlessly between controllers even when the controller management VLANs are different

Question 672

Refer to the exhibit. A network engineer is troubleshooting an issue with the file server based on reports of slow file transmissions. Which two commands or command sets are required to switch SW1 to analyze the traffic from the file server with a packet analyzer? (Choose two.)

A.SW1#show ip route

B.SW1(config)#monitor session 1 source interface gigabitethernet0/3
SW1(config)#monitor session 1 destination interface gigabitethernet0/1 encapsulation replicate

C.SW1#show monitor

D.SW1#show vlan

E.SW1(config)#monitor session 1 source interface gigabitethernet0/1 SW1(config)#monitor session 1 destination interface gigabitethernet0/3 encapsulation replicate

Question 673

DRAG DROP
Drag and drop the snippets onto the blanks within the code to construct a script that brings up the failover Ethernet port if the primary port goes down and also shuts down the failover port when the primary returns to service. Not all options are used.