Free Access Cisco.350-501.v2024-09-07.q358 Practice Test (Page 40)

Question 191

After troubleshooting multiple outages on the network due to repeated configuration errors, the network architect asked an engineer to enable NETCONF to facilitate future configurations. The configuration must enable syslog messaging to record NETCONF notifications from each of the numerous devices on the network. Which configuration must the engineer apply?

A.username cisco test taker privilege 15 password 0 ciscotest
aaa new-model
aaa authorization exec default local
snmp-server community ciscotest RW
netconf-yang cisco
logging history critical

B.username cisco test taker privilege 15 password 0 cisco test
aaa new-model
aaa authorization exec default local
snmp-server community cisco test RW
netconf-yang cisco-ia snmp-community-string ciscotest
logging history warnings

C.netconf-yang
username ciscotesttaker privilege 15 password 0 ciscotest
aaa new-model
aaa authorization exec default local
snmp-server community ciscotest RW
netconf-yang cisco-ia snmp-community-string ciscotest
logging history debugging

D.netconf-yang
username ciscotesttaker privilege 15 password 0 ciscotest
snmp-server community ciscotest RW
netconf-yang cisco-ia snmp-community-string ciscotest
logging history informational

Question 192

Refer to the exhibit. This output is included at the end of an output that was provided by a device using NETCONF.
What does the code show?

A.It shows that the full configuration is being modeled by YANG.

B.It shows NETCONF uses remote procedure calls.

C.It shows the hostname of the device as rpc-reply.

D.It shows that the running configuration is blank.

Question 193

Refer to the exhibit:
With which router does IOSXRV-1 have LDP session protection capability enabled but session hold up is not active?

A.192.168.0.3

B.192.168.0.5

C.192.168.0.1

D.192.168.0.4

Question 194

A network engineer is configuring a router to send multicast traffic for the 239.10.10.10 group. Which configuration must an .... forward the traffic?

A.Cisco(config)# interface ethernet 1/0 Cisco(config-if)# ip igmp join-group 239.10.10.10

B.Cisco(config)# interface ethernet 1/0 Cisco(config-if)# ip igmp max-groups action replace

C.Cisco(config)# interface ethernet 1/0 Cisco(config-if)# ip igmp filter

D.Cisco(config)# interface ethernet 1/0 Cisco(config-if)# ip igmp access-group 239.10.10.10