Free Access Cisco.350-501.v2024-09-07.q358 Practice Test (Page 43)

Question 206

Refer to the exhibit:

After implementing a new design for the network, a technician reviews the pictured CLI output as part of the MOP.
Which two statements describe what the technician can ascertain from the ImpNull output? (Choose two.)

A.Label 0 is used for the prefix displayed but will not be part of the MPLS label stack for packets destined for 192 168.10.10.

B.Label 0 is used for the prefix displayed and will be part of the MPLS label stack for packets destined for
192.168.10.10

C.Penultimate Hop Popping is in use for the prefix displayed

D.Label 3 is in use for the prefix displayed and will be part of the MPLS label stack for packets destined for 192.168.10.10

E.Ultimate Hop Popping is in use for the prefix displayed.

Question 207

Simulation 5
Refer to the exhibit.

Question 208

You are writing an RPL scnpt to accept routes only from certain autonomous systems Consider this code.

If you apply this code to BGP filters, which effect does the code have on your router?

A.allows routes from AS 7077

B.denies routes from AS 7007

C.denies routes from AS 7070

D.allows routes from AS 770

Question 209

Refer to the exhibit. An engineer at ISP C is configuring a new interconnection with ISPs A and B using the BGP protocol. After the initial configuration, the engineer noticed high memory usage and an abnormally large LIB table on router R2. Which two actions must the engineer take on R2 to minimize memory usage? (Choose two.)

A.Configure the mpls ldp neighbor 1.1.1.1 labels accept 101 command.

B.Configure Extended ACL 101 with accepted prefixes.

C.Configure the mpls ldp neighbor 21.21.21.21 labels accept 101 command.

D.Configure Standard ACL 1 with accepted prefixes.

E.Configure the mpls ldp neighbor 11.11.11.11 labels accept 1 command.

Question 210

Refer to the exihibit.

Refer to the exhibit. A network engineer is implementing BGP in AS 65101 and AS 65201. R3 sends data traffic to 192.168.1.1 /32 via the path R3-R2-R1. The traffic must travel via alternate path R6-R5 for prefix 192.168.1.1/32. Which action must be taken to meet the requirement?

A.Apply route-map HIGH-MED out on R2 for neighbor R3.

B.Apply route-map HIGH-LP in on R3 for neighbor R6

C.Apply route-map LOW-LP out on R2 for neighbor R3.

D.Apply route-map LOW-MED in on R5 for neighbor R2

Premium Bundle

Newest 350-501 Exam PDF Dumps shared by BraindumpsPass.com for Helping Passing 350-501 Exam! BraindumpsPass.com now offer the updated 350-501 exam dumps, the BraindumpsPass.com 350-501 exam questions have been updated and answers have been corrected get the latest BraindumpsPass.com 350-501 pdf dumps with Exam Engine here:

Access 350-501 Premium Version

(590 Q&As Dumps, 40%OFF Special Discount: Exam-Tests)

Other Version: 1380Cisco.350-501.v2024-01-16.q106; 4265Cisco.350-501.v2023-05-24.q291; 2067Cisco.350-501.v2023-01-07.q135; 3103Cisco.350-501.v2022-07-23.q124; 5408Cisco.350-501.v2022-03-26.q200

Latest Upload: 203PaloAltoNetworks.NGFW-Engineer.v2026-05-01.q43; 302Nokia.4A0-113.v2026-05-01.q69; 264EC-COUNCIL.312-49v11.v2026-04-30.q214; 230Microsoft.MB-820.v2026-04-30.q101; 213Salesforce.MC-202.v2026-04-30.q57; 207BICSI.INSTC_V8.v2026-04-29.q53; 337NMLS.MLO.v2026-04-28.q82; 245NCARB.Project-Management.v2026-04-28.q27; 466EMC.D-AV-DY-23.v2026-04-27.q184; 1125ServiceNow.CSA.v2026-04-27.q483