The RIP protocol is enabled on a router, the process number is 1, and the priority is 100; at the same time, the OSPF protocol is enabled, the process number is 100, and the priority is 10.
If these two processes have learned the route of the 10.0.0.0/8 network segment at the same time, and the metric values are 1 (hop count) and 100 (cost value) respectively, then the route 10.0.0.0/8 learned by which process will enter the IP route In the table?

In the following NSAP, the NET address that can be used as an integrated IS-IS is _______.

In the topology shown in the figure, perform the following configuration on the RTA:
RTA-ospf-1-area-0.0.0.1]network 192.168.0.0 0.0.0.255
RTA-ospf-1-area-0.0.0.1]network 192.168.1.0 0.0.0.255
RTA-ospf-1-area-0.0.0.1]network 192.168.2.0 0.0.0.255
RTA-ospf-1-area-0.0.0.1]network 192.168.3.0 0.0.0.255
Now it is required that the RTC cannot learn the routes configured in the above RTA. What configurations can be performed on the router?

Which of the following LSAs are propagated within an OSPFv3 area?

When configuring BGP to control routes, the commonly used filters are __________.