Question 31

Refer to the exhibit.

Eth0 and Eth1 on PE 3 are bound to VRF1 and VRF2, respectively. A valid static route 1.1.1.1/32 is imported to BGP domains from CE 1, CE 2, and CE 4, respectively. Which of the following statements are false?
  • Question 32

    Which of the following statements about the relationship between the SPE and the UPE are false?
  • Question 33

    As shown in the figure, the bearer network is deployed in full mesh mode. For example, RTA uses the physical interface ATM 1/0/0. The interface is devised into ATM 10/0.2 connect to RTC and RTD, respectively . The GigabiteEthernet 2/0/0 and GigabitEthernet 3/0/0 interface are used to set up a trunk as the VRRP heartbeat cable. The UMG work in active/standby mode. Media interface connected to RTA and RTB belong to VLAN 10. VRRP is enable at the VLAN interface RTA is the master router. The interface is configured as follows:

    Which of the following RTA configurations are correct in VLAN 10?
    A)

    B)

    C)

    D)
  • Question 34

    Exhibit:

    As shown in the figure, Super VLAN is enabled on SWA (a LAN switch). The Super VLAN configuration is as follows:

    Which of the following specifics the time order in which the preceding debugging information is generated?
  • Question 35

    Which of the following statements about control words in the L2VPN are true?