A.Running status data of the NE and the board

B.Equipment alarms and performance events

C.Configuration data for network elements and boards

D.Operation log of the network management

A.The total loss of the fiber will affect the actual detection distance. The dynamic range of the same detection mode is fixed. The larger the total loss of the fiber, the smaller the distance that can be detected.

B.Line fiber quality monitoring function increases the monitoring accuracy by adding the averaged results to the average. The actual time required from the start detection to the software returning the test result will be greater than the "detection time" is set.

C.Different modes of light pulse width are different in detection, pulse width affects distance accuracy and monitoring distance. The larger the pulse width, the larger the dynamic range, the longer the test distance and the higher the range measurement accuracy.

D.Increasing the pulse width increases the duration of the laser emission, which increases the energy injected, allowing for a larger dynamic range, but an increase in pulse width results in a larger dead zone.

A.FALSE

B.TRUE

A.Consistency check of network management and network element data.

B.Download the original configuration data

C.Query the alarm of the board and confirm that the original alarm has been cleared.

D.Ensure that the version of the host software is the same before and after the replacement.

A.Type

B.Payload

C.MPLS label

D.CW (Control Word)