Free Access Juniper.JN0-352.v2026-06-04.q78 Practice Test (Page 4)

Question 11

What is the default hello interval on an OSPF interface?

A.30 seconds

B.60 seconds

C.10 seconds

D.20 seconds

Question 12

Referring to the exhibit, all users connected to the same VLAN can communicate with each other, but not with users on other VLANs in this network.

What must be configured to enable communication between the VLANs?

A.The switch ports to which the users are connected should be configured as trunk ports.

B.A separate routing device is required to forward traffic between the configured VLANs.

C.A single logical IRB interface must be created and assigned to all three VLANs.

D.A logical IRB interface must be created and assigned to each VLAN.

Question 13

You are a network operator who wants to add a second ISP connection and remove the default route to the existing ISP You decide to deploy the BGP protocol in the network. What two statements are correct in this scenario? (Choose two.)

A.IBGP updates the next-hop attribute to ensure reachability within an AS.

B.IBGP peers advertise routes received from EBGP peers to other IBGP peers.

C.IBGP peers advertise routes received from IBGP peers to other IBGP peers.

D.EBGP peers advertise routes received from IBGP peers to other EBGP peers.

Question 14

You are attempting to configure the initial two aggregated Ethernet interfaces on a router but there are no aggregated Ethernet interfaces available.
In this scenario, which configuration will enable these interfaces on this router?

Question 15

Your network has two ISPs available. You want to ensure that all outbound traffic is routed out ISP-1. If the connection to ISP-1 fails, all outbound traffic is routed to the backup ISP, ISP-2. In this scenario, how should you configure BGP on your network?

A.Configure the gateway for ISP-1 with a higher peer ID than the gateway for ISP-2.

B.Set the local-preference attribute to a higher value for ISP-2 than ISP-1.

C.Set the local-preference attribute to a higher value for ISP-1 than ISP-2.

D.Configure the gateway for ISP-1 with a higher origin code than the gateway for ISP-2.

Latest Upload: 131Databricks.Databricks-Generative-AI-Engineer-Associate.v2026-08-18.q40; 137SAP.C_CR125_2601.v2026-08-17.q28; 179Salesforce.Field-Service-Consultant.v2026-08-17.q134; 150Oracle.1Z0-1170.v2026-08-16.q64; 157Oracle.1Z1-1170.v2026-08-16.q64; 193Juniper.JN0-336.v2026-08-13.q60; 327EMC.NCP-AII.v2026-08-13.q200; 205CIRO.RSE.v2026-08-12.q41; 175CrowdStrike.CCSE-204.v2026-08-12.q50; 162ISQI.CT-GenAI.v2026-08-11.q14

Question 11

Question 12

Question 13

Question 14

Question 15

Download PDF File