Question 6

You create a network region Region1 in Microsoft Teams.
You are adding a network site to Region1. The site has a 1.5-Mb connection.
You need to ensure that all users at the site have a good voice experience.
What should you do?
  • Question 7

    Note: This question is part of a series of questions that present the same scenario. Each question in the series contains a unique solution that might meet the stated goals. Some question sets might have more than one correct solution, while others might not have a correct solution.
    After you answer a question in this section, you will NOT be able to return to it. As a result, these questions will not appear in the review screen.
    Your company uses Microsoft Teams Calling Plans.
    The company acquires a small development team. Currently, users on the team have their own direct inward dial (DID) numbers that have PSTN capabilities.
    You migrate the users to Teams.
    You need to ensure that the users have phone numbers.
    Solution: From the Microsoft Teams admin center, you create a new port order.
    Does this meet the goal?
  • Question 8

    You need to provision a Microsoft Teams-certified common area phone device at a field site. The solution must ensure that a standard user can complete the physical handset tasks without sharing credentials.
    Which four actions should you perform in sequence? To answer, move the appropriate actions from the list of actions to the answer area and arrange them in the correct order.

    Question 9

    You have a Microsoft Teams Phone deployment.
    You are deploying Direct Routing by using a certified Session Border Controller (SBC). The FQDN of the S6C is sbcVcontoso.com. You use signaling port 5067.
    You cannot place calls and receive an error message m the Microsoft Teams admin center as shown in the following exhibit.

    What is a possible cause of the issue?
  • Question 10

    You have a Microsoft Teams Phone deployment.
    You are deploying a new remote site.
    You have a Session Border Controller (SBC) that has an E1/T1 Primary Rate Interface (PRI) deployed to the remote site.
    You plan to deploy a Survivable Branch Appliance (SBA) to ensure PSTN connectivity.
    Which type of endpoints is supported by the SBA?