Free Access Fortinet.NSE7_SDW-7.2.v2025-10-01.q108 Practice Test (Page 6)

Question 21

Refer to the exhibit.

Based on the exhibit, which two actions does FortiGate perform on traffic passing through port2? (Choose two.)

A.FortiGate always blocks all traffic, after a route change.

B.FortiGate flushes all routing information from the session table, after a route change.

C.FortiGate performs routing lookups for new sessions only, after a route change.

D.FortiGate does not change the routing information on existing sessions that use a valid gateway, after a route change.

Question 22

Refer to the exhibit.

Which two statements about the IPsec VPN configuration and the status of the IPsec VPN tunnel are true?
(Choose two.)

A.FortiGate does not install IPsec static routes for remote protected networks in the routing table. Most Voted

B.The phase 1 configuration supports the network-overlay setting. Most Voted

C.FortiGate facilitated the negotiation of the T_INET_1_0_0 ADVPN shortcut over T_INET_1_0.

D.Dead peer detection is disabled.

Question 23

Refer to the exhibits.
Exhibit A

Exhibit B

Exhibit A shows an SD-WAN event log and exhibit B shows the member status and the SD-WAN rule configuration.
Based on the exhibits, which two statements are correct? (Choose two.)

A.SD-WAN rule ID 1 is set to lowest cost (SLA) mode.

B.FortiGate updated the outgoing interface list on the rule so it prefers port2.

C.Port2 has a lower latency than port1.

D.Port2 has the highest member priority.

Question 24

Which two statements about SD-WAN central management are true? (Choose two.)

A.The objects are saved in the ADOM common object database.

B.It does not support meta fields.

C.It uses templates to configure SD-WAN on managed devices.

D.It supports normalized interfaces for SD-WAN member configuration.

Question 25

Refer to the exhibit.

Based on the exhibit, which two statements are correct about the health of the selected members? (Choose two.)

A.During passive monitoring, FortiGate can't detect dead members.

B.FortiGate passively monitors the member if TCP traffic is passing through the member.

C.FortiGate can offload the traffic that is subject to passive monitoring to hardware.

D.After FortiGate switches to active mode, FortiGate never fails back to passive monitoring.

Other Version: 2751Fortinet.NSE7_SDW-7.2.v2025-03-01.q95; 1556Fortinet.NSE7_SDW-7.2.v2024-11-26.q94; 1428Fortinet.NSE7_SDW-7.2.v2024-09-17.q87

Latest Upload: 140Fortinet.NSE7_SSE_AD-25.v2026-09-05.q85; 192Microsoft.PL-400.v2026-09-05.q375; 303Snowflake.DEA-C01.v2026-09-04.q215; 195HP.HPE0-V27.v2026-09-04.q127; 291NAHQ.CPHQ.v2026-09-03.q481; 124SAP.C-S4CPB-2602.v2026-09-02.q7; 138Cisco.700-805.v2026-09-02.q86; 171MSSC.CLT-4.0.v2026-09-02.q43; 135Fitness.NCSF-CPT.v2026-09-02.q18; 205Google.Generative-AI-Leader.v2026-09-02.q77

Question 21

Question 22

Question 23

Question 24

Question 25

Download PDF File