Using AD Query, the security gateway connects to the Active Directory Domain Controllers using Lightweight Directory Access Protocol (LDAP). LDAP is a protocol that provides access to directory services over a network. AD Query uses LDAP queries to retrieve information about users and groups from Active Directory Domain Controllers without installing any software on them. AD Query does not use Windows Management Instrumentation (WMI), Hypertext Transfer Protocol Secure (HTTPS), or Remote Desktop Protocol (RDP) to connect to Active Directory Domain Controllers. Reference: Check Point Certified Security Administrator (CCSA) R80.x Study Guide, Chapter 5: User Management and Authentication, page 69.

Explanation
The command that will allow the systems administrator to check whether the system supports virtualization is lscpu. This command will display information about the CPU architecture, such as the number of CPUs, cores, sockets, threads, model name, frequency, cache size, and flags. One of the flags is vmx (for Intel processors) or svm (for AMD processors), which indicates that the CPU supports hardware virtualization. If the flag is present, it means that the system supports virtualization. If the flag is absent, it means that the system does not support virtualization or that it is disabled in the BIOS settings.
The other options are not correct commands for checking whether the system supports virtualization. The dmidecode -s system-version command will display the version of the system, such as the product name or serial number, but not the CPU information. The sysctl -a command will display all the kernel parameters, but not the CPU flags. The cat /sys/devices/system/cpu/possible command will display the range of possible CPUs that can be online or offline, but not the CPU features. References: lscpu(1) - Linux manual page; How To Check If Virtualization is Enabled in Windows 10 / 11

Explanation
The system has reached its maximum permitted throughput, therefore iowait is increasing. The output of iostat
-x shows that the device sda has an average throughput of 44.01 MB/s, which is equal to the disk maximum throughput of 44 Mbps. The output also shows that the device sda has an average iowait of 99.99%, which means that the CPU is waiting for the disk to complete the I/O requests. This indicates that the disk is the bottleneck and the system is slow due to the high iowait. The other options are incorrect because they are not supported by the outputs. The system has not reached its maximum IOPS, as the device sda has an average IOPS of 563.50, which is lower than the disk maximum IOPS of 690. The system is not mostly idle, as the output of top shows that the CPU is 100% busy. The system does not have a partitioned disk, as the output of lsblk shows that the device sda has only one partition sda1. References: CompTIA Linux+ (XK0-005) Certification Study Guide, Chapter 17: Optimizing Linux Systems, pages 513-514.

The file that must be updated to ensure the filesystem mounts at boot time is /etc/fstab. This file contains information about the filesystems that are mounted automatically by the mount -a command, which is usually invoked during the system startup. The /etc/fstab file has six fields for each filesystem: device name, mount point, filesystem type, mount options, dump frequency, and pass number. To add a new filesystem to the /etc/fstab file, you need to specify these fields correctly and make sure the mount point directory exists.
The other options are not correct files for controlling persistent mount points of filesystems. The /etc/sysctl file is used to configure kernel parameters at runtime. The /etc/filesystems file is used to specify the order of filesystem types used by mount when no filesystem type is given. The /etc/nfsmount.conf file is used to set options for mounting NFS filesystems. Reference: Persistently mounting file systems; fstab(5) - Linux manual page