Free Access Cisco.300-410.v2025-02-03.q609 Practice Test (Page 65)

Question 316

An engineer configured a leak-map command to summarize EIGRP routes and advertise specifically loopback
0 with an IP of 10.1.1.1.255.255.255.252 along with the summary route. After finishing configuration, the customer complained not receiving summary route with specific loopback address. Which two configurations will fix it? (Choose two.)

A.Configure access-list 1 permit 10.1.1.0.0.0.0.3.

B.Configure access-list 1 permit 10.1.1.1.0.0.0.252.

C.Configure access-list 1 and match under route-map Leak-Route.

D.Configure route-map Leak-Route permit 10 and match access-list 1.

E.Configure route-map Leak-Route permit 20.

Question 317

Refer to the exhibit.

R1 has a route map configured, which results in a loss of partial IPv6 prefixes for the BGP neighbor, resulting in service degradation. How can the full service be restored?

A.The route map requires a deny 20 statement without set conditions, and this will allow additional prefixes to be advertised.

B.The prefix lit requires all prefixes that R1 is advertising to be added to it, and this will allow additional prefixes to be advertised.

C.The route map requires a permit 20 statement without set conditions, and this will allow additional prefixes to be advertised.

D.The neighbor requires a soft reconfiguration, and this will clear the policy without resetting the BGP TCP connection.