Free Access Cisco.300-410.v2025-02-03.q609 Practice Test (Page 63)

Question 306

An engineer must configure a Cisco router to initiate secure connections from the router to other devices in the network but kept failing. Which two actions resolve the issue? (Choose two.)

A.Configure a source port for the SSH connection to initiate

B.Configure a TACACS+ server and enable it

C.Configure transport input ssh command on the console

D.Configure a domain name

E.Configure a crypto key to be generated

Question 307

Refer to the exhibit. The forwarding entries how that the next hop for prefixes from the
172.16.0.0/16 network is set to 10.2.2.2 instead of 10.1.1.1. Which action resolves the issue?

A.Add set ip next hop 10.1.1.1 in route-map RED permit 20.

B.Add the continue statement in route-map RED permit 10 instead of continue 20.

C.Remove the continue 20 statement from route-map RED permit 10

D.Remove match ip address prefix-list 1 from route-map RED permit 10.

Question 308

Exhibit:

NTP is configured across the network infrastructure and Cisco DNA Center. An NTP issue was reported on the Cisco DNA Center at 17:15. Which action resolves the issue?

A.Check and resolve reachability between the WLC and the NTP server

B.Reset the NTP server to resolve any synchronization issues for all devices

C.Check and resolve reachability between Cisco DNA Center and the NTP server

D.Check and configure NTP on the WLC and synchronize with Cisco DNA Center

Question 309

Refer to the exhibits. An engineer filtered messages based on severity to minimize log messages.

After applying the filter, the engineer noticed that it filtered required messages as well. Which action must the engineer take to resolve the issue?

A.Configure syslog level 2.

B.Configure syslog level 3.

C.Configure syslog level 4.

D.Configure syslog level 5.

Question 310

Refer to the exhibit. An organization is installing a new L3 MPLS link to establish DM VPN Phase 2 tunnels between the hub and two spoke routers Which additional configuration should the engineer implement on each device to achieve optimal routing between the spokes?