Question 151
Refer to the exhibit.
Refer to the exhibit. Where must an architect plan for route summarization for the topology?
Refer to the exhibit. Where must an architect plan for route summarization for the topology?
Question 152
An architect must design a network solution for a regional medical center that will provide interconnectivity between regionally dispersed data centers and a new colocation. The design must:
- utilize point-to-point connectivity
- utilize existing VLAN infrastructure
- increase performance for data center synchronization and backup
processes
- reduce configuration complexity
Which solution must the engineer choose?
- utilize point-to-point connectivity
- utilize existing VLAN infrastructure
- increase performance for data center synchronization and backup
processes
- reduce configuration complexity
Which solution must the engineer choose?
Question 153
A company wants to enable several third-party video conferencing networks based on multicast services. The video conferencing platform can accommodate numerous and dispersed senders and receivers in third-party networks. The interior routing protocol is OSPF and the exterior routing protocol is BGP. Which multicast mode must be selected to achieve this goal?
Question 154
Refer to the exhibit. An architect is designing an IPv4 plan using the 172.16.0.0/16. The design must maximize the number of subnets while meeting these requirements:
- 500 hosts within the server room
- 100 hosts at the remote site
- 25 hosts at the access site
Which plan must the architect choose?
- 500 hosts within the server room
- 100 hosts at the remote site
- 25 hosts at the access site
Which plan must the architect choose?
Question 155
Refer to the exhibit.
Refer to the exhibit. The connection between SW2 and SW3 is fiber and occasionally experiences unidirectional link failure. An architect must optimize the network to reduce the change of layer2 forwarding loops when the link fails. Which solution should the architect include?
Refer to the exhibit. The connection between SW2 and SW3 is fiber and occasionally experiences unidirectional link failure. An architect must optimize the network to reduce the change of layer2 forwarding loops when the link fails. Which solution should the architect include?