A smart switch has the ability to monitor electrical levels and shut off power to a building in the event of power surge of power surge or other fault situation. The switch was installed on a wired network in a hospital and is monitored by the facilities department via a cloud application. The security administrator isolated the switch on a separate VLAN and set up a patching routine. Which of the following steps should also be taken to harden the smart switch?

During a routine scan of a wireless segment at a retail company, a security administrator discovers several devices are connected to the network that do not match the company's naming convention and are not in the asset Inventory. WiFi access Is protected with 255-Wt encryption via WPA2. Physical access to the company's facility requires two-factor authentication using a badge and a passcode Which of the following should the administrator implement to find and remediate the Issue? (Select TWO).

A forensics investigator is examining a number of unauthorized payments the were reported on the company's website. Some unusual log entries show users received an email for an unwanted mailing list and clicked on a link to attempt to unsubscribe. One of the users reported the email to the phishing team, and the forwarded email revealed the link to be:

Which of the following will the forensics investigator MOST likely determine has occurred?

A security engineer is setting up passwordless authentication for the first time.
INSTRUCTIONS
Use the minimum set of commands to set this up and verify that it works. Commands cannot be reused.
If at any time you would like to bring back the initial state of the simulation, please click the Reset All button.

Select the appropriate attack and remediation from each drop-down list to label the corresponding attack with its remediation.
INSTRUCTIONS
Not all attacks and remediation actions will be used.
If at any time you would like to bring back the initial state of the simulation, please click the Reset All button.